I think I narrowly avoided a battery fire or explosion in the shack this morning. For the last 18 months or so I have been using my old HTC Touch 2 smartphone as my 2m APRS iGate (I hated it as a phone.) All that time it has been sitting in the desktop cradle talking to my Kenwood TM-D710 TNC via a Bluetooth connection and providing a 24/7 gateway that is silent (unlike my PC) and uses less power.
This morning Colin M0XSD sent me an APRS message and I took the phone out of the cradle so I could use its keyboard to reply. I noticed that it felt quite hot. After about 5 minutes conversation the battery died. Having been on permanent charge that should not have happened.
 |
| My dead Touch 2 battery - can you see the bulge? |
I took the still warm Li-Ion battery out of the phone and noticed there was a distinct bulge on both sides of the casing. So I suppose that it was on the way to exploding or catching fire. Unfortunately the phone won't work with the battery removed and powered only from the desktop cradle. So my G4ILO-2 iGate is off the air. I will think again about the wisdom using a permanently-charged smartphone as an iGate in the future!
6 comments:
I had a Macbook Li-ion battery that went the same way. The Macbook was permanently connected to the charger. The case bulged so much that the trackpad stopped working as the battery was pushing against it from underneath. It had to be disposed of. I'm very wary about having Li-ion batteries connected to a charger permanently now.
Steve G0KYA
I've also had this happen to a macbook and a Magellan GPS device. I wonder if the battery really must be in a charging state to fail this way? I would like a good explanation for what has gone wrong with these batteries, because the charge circuitry is supposed to prevent this kind of thing.
I had a HTC smartphone 3 years ago, and I would NEVER go back to one, weak signals/ reception compared to my girlfriends phone on the same network / location,
Thanks for the "tip" thou
73
Andy ,m0HLT
Hmmm reading the post's here made me think about our Mac Air and it's plugged in all the time to the charger. I may now just charge it and unplug it after reading of all the Mac battery issues here.
Mike
As someone who had to deal with several Li-Ion battery charging "near disasters" in PMR TETRA radios in my professional life, I can confirm that such battery problems are far more common than people let on: too expensive to admit a major brand PC or radio has an issue and needs a major recall. I NEVER leave Li-Ion batteries charging for long without supervision. Never leave a laptop charging under the settee at night. Some issues can be made worse by dropping the battery packs. If in any doubt safely dispose of the battery pack and buy a new one. They have high capacity but they are potential flame throwers when they go. I hope the Dreamliner gets sorted BTW.
73s
Roger G3XBM
I had a same incident with a Li-Ion battery in my HP Ipaq 4150 once. After that, I removed rechargeable batteries from my laptops/phones that are constantly sitting on the desk and connected to AC via a UPS (uninterruptible power supply). This way during blackouts they still run fine as long as the lead-acid battery in the UPS is charged.
Also, I believe you can wire power from a regulated power supply right to the terminal leads in your HTC phone and avoid the craddle. I did this once by making a custom insert shaped as the battery with the wires from a power supply going to the exact locations of the terminals. This way I could insert it instead of the battery and then power it from the power supply.
To do that, I pressed the battery into some warm paraffin to get the pressform, and then filled the form with epoxy while putting the power supply cable wires soldered to terminals next to where they are supposed to be on the battery. It worked out quite well.
Post a Comment