Thursday, November 21, 2013

Desk stand for an Elecraft KX3

A surprise package dropped through the door yesterday afternoon. (I do like surprises!)  It was a SOTA Beams desk stand for the Elecraft KX3, customised with my callsign.

SOTA Beams desk stand for Elecraft KX3
In the absence of instructions and with the aid of a couple of the photos on the SOTA Beams website it took my poor brain a couple of minutes to work out how it went together. Actually there are a couple of self adhesive rubber feet and a length of edge trim the purpose of which are still not entirely clear to me.

The stand is robustly made from a laser cut  perspex type material and holds the KX3 at the perfect angle for desktop use.  (I'm not sure how that would be with the KXPD3 paddle. I didn't try it as with my shaky hands I can only send dits at the moment. :)

This stand is exactly what I have been looking for to hold the KX3 when operating sitting on the ground with the rig beside you. The viewing angle is just right for that too - much better than standing your nice radio on the damp and dirty ground. The bright orange of the one SOTA Beams sent me  (they are also available in black or red apparently) makes the stand highly visible and so less likely to be accidentally left behind on the summit or other operating spot.

The perfect angle for desktop or portable operation
Thanks, Richard! This is definitely going in the case with the Alex Loop ready forwhen  my health improves enough for me to take a radio into the Great Outdoors again.
Post a Comment